Honeywell 30 Series User Manual

27
Honeywell 30 Series IP Cameras User Guide
time. By default, the start and end time of day mode are set to 07:00 and 18:00.
Sensitivity of IR: Adjust the responsiveness of the IR filter to lighting conditions as Low,
Normal, or High.
Configuring Video Settings
Go to Setup  Camera Setup  Video.
This section describes how to configure viewing window and video streaming properties
(format, resolution, frame rate, bit rate, I-frame interval and so on.).
Mode
Go to Setup  Camera Setup  Video  MODE.
In MODE tab, you can set the pixel mode for different cameras.
Note:
Changing the video mode will clear the following settings: privacy mask, exposure
widow, motion and focus window.
Figure 32 Mode Tab 1
4-Megapixel (Max Resolution 2688x1520): Select it and the maximum resolution will
be 2688x1520. The aspect ratio will be 16:9. This mode applies to
HC30W45R3/HC30W45R2/HC30WB5R1/HC30WB5R2/HC30WE5R3/
HC30WE5R2/HC30W25R3/HC30W25R3-12V cameras (see Figure 32).
5-Megapixel (Max Resolution 2560x1920): Select it and the maximum resolution will
be 2560x1920. The aspect ratio will be 4:3. This mode applies to
HC30W45R3/HC30W45R2/HC30WB5R1/HC30WB5R2/HC30WE5R3/
HC30WE5R2/HC30W25R3/HC30W25R3-12V cameras (see Figure 32).
Figure 33 Mode Tab 2
Fisheye (Max Resolution 1920x1920): Select it and the maximum resolution will be
1920x1080. This mode applies to HC30WF5R1 cameras (see Figure 33).

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)