Honeywell 30 Series User Manual

43
Honeywell 30 Series IP Cameras User Guide
Enable IPv6
Select this option and click SAVE to enable IPv6 settings.
Note:
This function only works if your network environment and hardware equipment
support IPv6. The browser should be Microsoft® Internet Explorer 11.0+ or Chrome
71+.
Figure 49 Enable IPv6
When IPv6 is enabled, by default, the network camera will listen to router
advertisements and be assigned with a link-local IPv6 address accordingly.
IPv6 Information: Click to obtain the IPv6 information as shown below.
Figure 50 IPv6 Information
If your IPv6 settings are successful, the IPv6 address list will be listed in the pop-up
window.
Follow the steps below to link to an IPv6 address:
1. Open your web browser.
2. Enter the link-global or link-local IPv6 address in the address bar of your web browser.
3. The format should be: http://[2001:0c08:2500:0002:0202:d1ff:fe04:65f4]/
4. Press Enter on the keyboard or click Refresh button to refresh the webpage.

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)