EasyManuals Logo

Honeywell 30 Series User Manual

Honeywell 30 Series
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
42
Honeywell 30 Series IP Cameras User Guide
Fixed IP address: Check to manually assign a static IP address to the camera.
IP address:
1. Use Unified Tool in the software CD to set up the camera on LAN. See Accessing the
Camera on page 4.
2. Enter the Static IP, Subnet mask, Default router, and Primary DNS provided by your
ISP or network administrator.
Subnet mask: This is used to determine if the destination is in the same subnet. The
default value is 255.255.255.0.
Default router: This is the gateway used to forward frames to destinations in a
different subnet. Invalid router setting will disable the transmission to destinations
across different subnets.
Primary DNS: The primary domain name server that translates hostnames into IP
addresses.
Secondary DNS: Secondary domain name server that backups the Primary DNS.
Primary WINS server: The primary WINS server that maintains the database of
computer names and IP addresses.
Secondary WINS server: The secondary WINS server that maintains the database of
computer names and IP addresses.
Enable UPnP presentation: Check to enable UPnP presentation for your camera so that
whenever a camera is presented to the LAN, the shortcuts to connected cameras will be
listed in Network and Sharing Center. You can click the shortcut to link to the web
browser.
Note: Click SAVE to enable the settings after you completed the settings on each page.
Enable UPnP port forwarding: Check to allow the camera to open ports automatically
on the router so that video streams can be sent out from a LAN. To utilize of this feature,
make sure that your router supports UPnP and it is activated.
Enabling UPnP in Windows
The UPnP protocol is used to detect network devices with clients running Windows.
The camera can be detected by Windows' built-in network browser.
To enable UPnP in Windows 10:
1. Go to Start Control Panel Network and Sharing Center.
2. On the left pane, click Change advanced sharing settings.
3. On your current network profile of the Network discovery area, click Turn on network
discovery, and then click Save changes.

Table of Contents

Other manuals for Honeywell 30 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell 30 Series and is the answer not in the manual?

Honeywell 30 Series Specifications

General IconGeneral
Video CompressionH.264
Series30 Series
CategorySecurity Camera
Night VisionYes
Power SourceWired
Motion DetectionYes
Weather ResistanceYes
LensFixed
StorageMicroSD card (up to 128GB)

Related product manuals