Honeywell 30 Series - Configuring Streaming Protocols; Figure 51 Manually Setup IP Address; Figure 52 Streaming Protocols - HTTP

44
Honeywell 30 Series IP Cameras User Guide
Note:
If you have a Secondary HTTP port (the default value is 8080), you can also link to
the webpage using the following address format: (see Configuring Streaming
Protocols on page 44 for detailed information.)
Manually setup the IP address: Check to manually set up IPv6 settings if your network
environment does not have DHCPv6 server and router advertisements-enabled routers.
If you check this item, the following blanks will be displayed for you to enter the
corresponding information:
Figure 51 Manually Setup IP Address
Configuring Streaming Protocols
Go to SetupNetwork SetupStreaming Protocols.
Figure 52 Streaming Protocols - HTTP
To utilize HTTP authentication, make sure that you have set a password for the camera
first. For more information, see Configuring User Accounts Settings on page 82.
Authentication (digest): User credentials are encrypted with MD5 algorithm which
provide better protection against unauthorized accesses.
HTTP port: By default, the HTTP port is set to 80. It can also be assigned to another port
number between 1025 and 65535.