Honeywell 30 Series User Manual

33
Honeywell 30 Series IP Cameras User Guide
• G.711 provides good sound quality and requires about 64Kbps. Select pcmu (μ-Law)
or pcma (A-Law) mode.
• G.726 is a speech codec standard covering voice transmission at rates of 16, 24, 32,
and 40kbit/s.
After you complete the settings on this page, click SAVE to enable the settings.
Configuring IR Control Settings
Go to Setup  Camera Setup  IR Control.
On this page, you can turn on the IR illuminator and adjust the luminance of IR lights.
Figure 39 IR Control Settings
IR Illuminators
Turn on built-in IR illuminator in night mode: Check to turn on the camera’s onboard
IR illuminator when the camera detects low light condition and enters the night mode.
Smart IR
Anti-overexposure: Check to automatically adjust the shutter speed, Gain and IRIS
through algorithm of the firmware to avoid over-exposure in the night mode.
Note:
The IRIS control only applies to HC30W45R2/HC30WB5R2/HC30WE5R2
motorized focus/zoom cameras.
IR adjustment: Adjust the luminance of IR lights.
Figure 40 Smart IR
Manual IR adjust: Check it to control the luminance of IR lights manually. To increase
the luminance of IR lights, drag the slider to the right; to decrease the luminance of IR
lights, drag the slider to the left.

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)