74
Honeywell 30 Series IP Cameras User Guide
Figure 89 Recording Settings Details
• Recording name: Enter a name for the recording setting.
• Enable this recording: Select this option to enable video recording.
• With adaptive recording:
Select this option will activate the frame rate control according to alarm trigger.
The frame control means that when there is a triggered alarm, the frame rate will raise
up to the value you’ve configured on the Video quality page. For more information, see
Smart Codec Configuration on page 30.
If you enable adaptive recording on a camera, only when an event is triggered on camera
will the server record the full frame rate streaming data; otherwise, it will only request the
I frame data during normal monitoring, thus effectively saves bandwidths and storage
space.
Note:
To enable adaptive recording, make sure you’ve set up the trigger source such
as Motion Detection or Manual Trigger. For more information, see
Configuring
Event Settings on page 61.
•
When there is no alarm trigger:
•
JPEG mode: record 1 frame per second.
•
H.264 mode: record the I frame only.
•
When the I frame period is >1s on Video settings page, firmware will force
decreasing the I frame period to 1s when adaptive recording is enabled.
• Pre-event recording and post-event recording
The camera has a buffer that temporarily holds data for a period. Therefore, when an
event occurs, the camera can retrieve image frames taken several seconds ago.
Enter a number to define the duration of recording before and after a trigger is
activated.
• Priority: Select the relative importance of this recording (High, Normal, or Low).
To Next Page
Loading...
Need help?
General
