Honeywell 30 Series User Manual

70
Honeywell 30 Series IP Cameras User Guide
• Cameras ** refers to: HC30W25R3/HC30W25R3-12V
Note:
•
It is recommended to use the Class 10 SD card.
• It is recommended to turn OFF the recording activity before you remove an SD
card from the camera.
• The lifespan of an SD card is limited. Regular replacement of the SD card can be
necessary.
• Camera file system takes up several megabytes of memory space. The storage
space cannot be used for recording.
• Using an SD card that already contains data recorded by another device should
not be used in this camera.
• Do not modify or change the folder names in the SD card. That may result in
camera malfunctions.
• If you want to use the SD card in another camera, format the SD card in another
camera first. For how to format the SD card, see SD Card Format on page 70 .
SD Card Status
This tab shows the status and reserved space of your SD card. Remember to format the
SD card when using it for the first time, see
SD Card Format on page 70 .
Figure 81 No SD Card
Figure 82 SD Card Onboard
SD Card Format
To format the SD Card, click FORMAT.
Note:
• SD card encryption by LUKS (Linux Unified Key Setup)
•
Please wait for a while to format a SD card. It takes 1 to 2 minutes to format a 4G
SD card, 10 to 15 minutes to format a 128G card, and 15 to 25 minutes to
format a 256G card.

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)