Honeywell 30 Series User Manual

82
Honeywell 30 Series IP Cameras User Guide
Update Daylight Saving Time Rules
Follow the steps below to update daylight saving time rules:
1. Click CHOOSE FILE under “Update daylight saving time rules”.
2. Select the XML file to update.
3. Click UPLOAD.
Update Custom Language File
1. Click CHOOSE FILE under “Update custom language file”.
2. Select your custom language file to update.
3. Click UPLOAD.
4. Go to the main page (see Figure 17), and select your own custom language from the
Language menu to apply the custom language.
Upload Configuration File
Follow the steps below to upload a configuration file:
1. Enter a password for uploading the configuration file.
The password must be the same as the password of the configuration file you set for
exporting, or the uploading will be failed. For example, if you set a password A for a
configuration file A and you set a password B for a configuration file B. When you want
to upload the configuration file B, you must use the password B.
2. Click CHOOSE FILE to locate the configuration file and then click UPLOAD to upload
the configuration file.
Note:
The model and firmware version of the device should be the same as the
configuration file. If you have set up a fixed IP or other special settings for your
device, it is not suggested to update a configuration file.
Configuring User Accounts Settings
Go to Setup  System Setup  User Accounts.
This section describes how to create multiple accounts and grant privileges to these
accounts.

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)