MPA2C3 User Manual 65
Configuring Discription
3. Select Scheduling
4. Click Save.
Name Enter a unique name to identify the lock output
Pulse Time Configure how long a device assume to be normal status such as a hours,
minutes and seconds, Maximum time is 1:45:59
Latch Toggle the start of the outputs between energized and de-energized upon
every activation (code use, interlock, or manual pulse) Interlocks Disable/
enable interlocks. See Interlock Configuration, page 77 for more
information about Interlocks
TZ Card Toggles Requires like the First Card Rule, a valid card read within the time zone to
enable the time zone (periods in which the doors are unlocked) to take
effect. Unlike the First Card Rule, however the user can swipe the card a
second time to return the doors to a locked
Note: Effective only if the output has a valid schedule for Energized in
the Section Scheduling. Both TZ Card Toggle and First Card Rule
cannot be enabled at the same time
First Card Rule First Card Rule requires a valid card read within the time zone to enable
the time zone (period in which the doors are unlocked) to take effect.
Note: Effective only if the output has a valid schedule for Energized in
the section Scheduling. Both TZ Card Toggle and First Card Rule
cannot be enabled at the same time.
Configuration Description
Energized Specifies the period during which the output relay is automatically
in the state where the door is unlocked (Energized or De-
energized-when FACP is in use).
Select the Schedule (that you created in Configuring
Schedules, page 45from the drop down list. The Energized state of
the output can be affected by the Enabled setting for the TZ Card
Toggle or First Card R
Disable Interlocks
Specifies the period during which the Interlock that controls the
output will be disabled, Select a Schedule (that you created in
Configuring Schedules, page 45from the dropdownlist.
To Next Page
Loading...
