Notice
Copyright
@
1994
Hewlett-Packard
GmbH.
Herrenberger
Sir.
130
7 1034 Riiblingen
Federal
Repubhc
of Germany
All
Rrghm
Reserved. Reproduction,
adaptation or translation without prior
written permission is prohibited. except
as allowed under the copyright laws.
warranty
The information contained in this
document
IS
subject to change without
notice.
Hewbtt-Rwhmvd
makes
no
ummnty
of
any kind with regard to this material,
includiv~q,
but not
limited
tq
the implied
zuarranties
or
merchuntibility
and
pnmfi
a particular
pwp0se
Hewlett-Packard shall not be liable for
errors
contained herein or for incidental
or
consequentral
damages in connection
with the furnishing, performance, or use
of this material.
Complete product warranty information
is given in the User Guide.
Safety
This is a Safety Class 1 instrument
(provided with terminal for protective
earthmg).
Before applying power, verify
that the correct safety precautions are
taken (see the following warnings). In
addition, note the external markings on
the instrument that are described under
Safety Symbols. Do not operate the
mstrument
wrth
its covers removed.
Replace fuse only with specified type.
Warning
Before turning on the instrument, you
must connect the protective earth
terminal of the instrument to the
protective earth conductor of the (mains)
power cord. The mains plug must only be
inserted in a socket outlet with a
protective earth contact. Do not negate
the protective action by using an
extension power cord without a
protective grounding conductor.
Grounding one conductor of a
two-conductor outlet is not sufficient
protection.
Service instructions are for trained
service personnel. lb avoid dangerous
electric shock, do not perform any
service unless qualified to do so. Do not
attempt internal service or adjustment
unless another person, capable of
rendering
Arst
aid and resuscitation, is
present.
If you energize this instrument using an
auto-transformer (for voltage reduction)
make sure that the common terminal is
connected to the earth terminal of the
power source.
Whenever it is likely that the ground
protection is impaired, you must make
the instrument inoperative and secure
It
against any unintended operation.
Do not operate the instrument in the
presence of flammable gases or fumes.
Operation of any electrical instrument in
such an environment constitutes a
definite
safe@
hazard.
Do not install substitute parts or perform
any unauthorized modification to the
instrument.
Capacitors inside the instrument may
retain a charge even if the instrument is
disconnected from its source of supply.
Safety Symbols
A
4
Instruction Manual symbols: The
instrument is marked with this symbol
when it
IS
necessary for you to refer to
the instruction manual in order to avoid
the hazard of electric shock.
A
I
Instruction Manual symbols: The
instrument is marked with this symbol
when it is necessary for you to refer to
the instruction manual in order to protect
against damage to the instrument.
Protected conductor symbol
WARNING
The Warning symbol calls attention to a
procedure, practice, or the like, which, if
not correctly performed or adhered to,
could result in personal injury or loss of
life. Do not proceed beyond a Warning
symbol until the indicated conditions are
fully understood and met.
CAUTION
The Caution symbol calls attention to a
procedure, practice, or the like, which, if
not correctly performed or adhered to,
could result
In
damage to or destruction
“f
part or
aI\
of the equipment. Do not
proceed
beyend
a Caution symbol until
the indicated conditions are fully
understood
end
met.
To Next Page
Loading...
