HP 8114A - Page 50

2. Select the TRIGGER page on the HP 8114A and set up as follows:
The TRIGGER Page Set-up
3. On the HP 8114A set up OUTPUT page as shown in the following
illustration:
n
Per I .00Lls Out ON
Inh OFF f
II
DblDel
m Baselne +0.00V
Width 10.0% kplitd 5.00V
I 20.0 II
150R into 50.0 R JL~.- Positive1 175~ 1
1 TRIGGER I I OUTPUT I I LIMITS 1 t-1
Configuring the Output Page
4. Set the Digitizing Oscilloscope HP 54121T:
I Set scope timebase to 5 nsidiv
w Center the double pulse signal
n Select the Display menu and set the Number of Averages to 32
I Select the Delta V menu and turn the Voltage markers On
3-14 Testine the HP 8114A