7 ==> SP File Transfer Trigger
8 ==> Reset Quiesce state in Transfer process
9 ==> Mount a CDROM
10 ==> Unmount a CDROM
11 ==> SP Date/Time/Geographical Location maintenance
12 ==> Manage NTP configuration
13 ==> Display SP status
14 ==> SP User Access Control
15 ==> SP Process Control Parameters
16 ==> Maintain SP Software
17 ==> SP File Maintenance
18 ==> RESERVED
19 ==> Request a SPLOR
20 ==> Request an MSPLOR
21 ==> Run SPCheckhealth
22 ==> SP Certificate Information
X Return to previous menu
14. Enter Y to confirm that you want to halt and power off the SP.
1.3.1 SP SHUTDOWN
HP 3PAR Service Processor Menu
Transfer media: ethernet Transfer status: Ok
Confirmation
Enter Control-C at any time to abort this process
Halt will power off the SP!
Are you certain you want to halt the SP now?
(y or n)
15. Set all power breakers on the PDUs to the OFF position.
CAUTION: For safety precaution, all drive magazines must be properly grounded before
removing from the drive chassis.
16. Unplug the system main power cords.
17. For system and drive expansion cabinets, coil all main powers cords and strap the cable
along the mounting rails on the side of the cabinet panel. Use a cable tie wrap to secure the
cords inside the rack.
18. Disconnect all external connections from the host computer(s) and drive cage expansion
racks to the system and remove the cables from the rack. Leave the internal Fibre Channel
and SP connections intact if possible.
19. Insert dust plugs into all open system Fibre Channel ports and secure all Fibre Channel,
Ethernet, and serial cables remaining inside the rack.
Uninstalling the System 137
To Next Page
Loading...
