46 mm leading edge blur
Figure 2-107 46 mm leading edge blur
Description of the defect
A dark and usually sharp band occurring 46 mm from the leading edge. This impulse band is a latent image
caused by the leading edge of the media entering the transfer nip.
Conditions that can cause the defect
This defect occurs in ll areas. This does not occur in text regions.
Solutions for the defect
●
Resend the job.
●
If the defect is persistent, try printing in Quiet Mode (1/2 speed) which, because of the slower process
speed, allows the media to enter the transfer nip more reliably and with less impact force.
At the printer control panel open the following menus: Settings > General > Quiet Mode > On.
Parts related to the defect
NOTE: The following item(s) might need to be repaired or replaced to prevent this defect form occurring.
●
Media
●
Paper path
266 Chapter 2 Solve problems ENWW
To Next Page
Loading...