50 mm trailing edge blur
Figure 2-109 50 mm trailing edge blur
Description of the defect
A dark and usually sharp band occurring 50 mm from the trailing edge. This impulse band is a transfer blur
caused by the trailing edge of the media exiting the registration rollers.
Conditions that can cause the defect
This defect occurs in ll areas. This does not occur in text regions.
Solutions for the defect
●
Resend the job.
●
If the defect is persistent, try printing in Quiet Mode (1/2 speed) which, because of the slower process
speed, allows the media to enter the transfer nip more reliably and with less impact force.
At the printer control panel open the following menus: Settings > General > Quiet Mode > On.
Parts related to the defect
NOTE: The following item(s) might need to be repaired or replaced to prevent this defect form occurring.
●
Media
●
Paper path
268 Chapter 2 Solve problems ENWW
To Next Page
Loading...