HP LaserJet Enterprise M607n - USB Flash Drive (Control-Panel Menu)

USB ash drive (control-panel menu)
NOTE: USB ash drives that are not using a FAT32 format, or do not have a CD formatted partition, might
not be recognized by the printer. If the printer does not recognize a USB ash drive, try using a dierent USB
ash drive.
TIP: The USB port on the printer must be enabled. If it is disabled, use the Enable Retrieve from USB item in
the General Settings menu to enable it.
USB ash drive rmware (control-panel menu) update from a touchscreen control panel
1. Copy the .bdl le to a portable USB ash drive.
2. Turn the printer on, and then wait until it initializes.
3. From the Home screen on the printer control panel, swipe (right), and the touch the Support Tools item.
4. Open the following menus:
●
Maintenance
●
USB Firmware Upgrade
5. Insert the USB ash drive with the .bdl le on it into the USB port on the printer.
6. Touch the .bdl le, and then touch the Install button.
NOTE: If there is more than one .bdl le on the storage device, make sure to select the correct le for
this printer.
7. When the upgrade is complete, the printer restarts.
TIP: Print a conguration page and verify that the upgrade rmware version was installed.
USB ash drive rmware (control-panel menu) update from a LCD control panel
1. Copy the .bdl le to a portable USB ash drive.
2. From the Home screen on the printer control panel, use the down arrow button to select the Print
menu.
3. Use the right arrow button to scroll to and select the Support Tools menu, and then press the OK
button.
4. Use the down arrow button to scroll to and select the Maintenance menu, and then press the OK
button.
5. Use the down arrow button to scroll to and select the USB Firmware Upgrade menu, and then press
the OK button.
6. Insert the USB ash drive with the .bdl le on it into the USB port on the printer.
7. Use the down arrow button to scroll to the appropriate .bdl le, and then press the OK button to
select.
ENWW Firmware upgrades 381