HPE FlexFabric 5940 SERIES Configuration Guide

4
Step Command Remarks
7. Restore the default
settings for the Ethernet
interface.
default
N/A
8. Bring up the Ethernet
interface.
undo shutdown
By default, Ethernet interfaces are in up
state.
The
loopback, shutdown
,and
port
up-mode
commands are mutually
exclusive.
Configuring an Ethernet subinterface
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an Ethernet
subinterface.
interface
interface-type
interface-number.subnumber
N/A
3. Set the description for the
Ethernet subinterface.
description
text
The default setting is
interface-name
Interface
. For
example,
Ten-GigabitEthernet1/0/1.1
Interface
.
4. Restore the default settings
for the Ethernet subinterface.
default
N/A
5. Set the expected bandwidth
for the Ethernet subinterface.
bandwidth
bandwidth-value
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided by
1000.
6. Bring up the Ethernet
subinterface.
undo shutdown
By default, Ethernet subinterfaces
are in up state.
The
shutdown
and
port
up-mode
commands are mutually
exclusive.
Configuring the link mode of an Ethernet interface
CAUTION:
After you change the link mode of an Ethernet interface, all commands (except the shutdown
command) on the Ethernet interface are restored to their defaults in the new link mode.
The interfaces on this Switch Series can operate either as Layer 2 or Layer 3 Ethernet interfaces.
You can set the link mode to bridge or route.
To configure the link mode of an Ethernet interface:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet interface
view.
interface
interface-type
interface-number
N/A
3. Configure the link mode of
the Ethernet interface.
port link-mode
{
bridge
|
route
}
By default, Ethernet interfaces
operate in bridge mode.

HPE FlexFabric 5940 SERIES Specifications

General

Brand	HPE
Model	FlexFabric 5940 SERIES
Category	Switch
Language	English