HPE FlexFabric 5940 SERIES Configuration Guide

61
group-specific link-aggregation traffic redirection is not configured, the group uses the global
link-aggregation traffic redirection settings.
Configuration restrictions and guidelines
When you enable link-aggregation traffic redirection, follow these restrictions and guidelines:
• Link-aggregation traffic redirection applies only to dynamic link aggregation groups.
• To prevent traffic interruption, enable link-aggregation traffic redirection on devices at both ends
of the aggregate link.
• To prevent packet loss that might occur when a slot reboots, do not enable spanning tree
together with link-aggregation traffic redirection.
• Link-aggregation traffic redirection does not operate correctly on an edge aggregate interface.
• As a best practice, enable link-aggregation traffic redirection on aggregate interfaces. If you
enable this feature globally, communication with a third-party peer device might be affected if
the peer is not compatible with this feature.
Configuration procedure
To enable link-aggregation traffic redirection globally:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable link-aggregation
traffic redirection globally.
link-aggregation lacp
traffic-redirect-notification
enable
By default, link-aggregation traffic
redirection is disabled globally.
To enable link-aggregation traffic redirection for an aggregation group:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
N/A
3. Enable link-aggregation
traffic redirection for the
aggregation group.
link-aggregation lacp
traffic-redirect-notification
enable
By default, link-aggregation traffic
redirection is disabled for an
aggregation group.
Forwarding the traffic of specified VLANs out of a
fixed member port on an aggregate link
To forward the traffic in specific VLANs out of a fixed port on an aggregate link, specify those VLANs
as management VLANs and specify that port as a management port.

HPE FlexFabric 5940 SERIES Specifications

General

Brand	HPE
Model	FlexFabric 5940 SERIES
Category	Switch
Language	English