64
Task Command
Display forwarding information for the specified
traffic flow.
display link-aggregation load-sharing path interface
{
bridge-aggregation
|
route-aggregation
}
interface-number
ingress-port
interface-type
interface-number [
route
] { {
destination-ip
ip-address |
destination-ipv6
ipv6-address } | {
source-ip
ip-address |
source-ipv6
ipv6-address } |
destination-mac
mac-address |
destination-port
port-id |
ethernet-type
type-number |
ip-protocol
protocol-id |
source-mac
mac-address |
source-port
port-id |
vlan
vlan-id } *
Display detailed link aggregation information
for link aggregation member ports.
display link-aggregation member-port
[ interface-list ]
Display summary information about all
aggregation groups.
display link-aggregation summary
Display detailed information about the
specified aggregation groups.
display link-aggregation
verbose
[ {
bridge-aggregation
|
route-aggregation
}
[ interface-number ] ]
Clear LACP statistics for the specified link
aggregation member ports.
reset lacp statistics
[
interface
interface-list ]
Clear statistics for the specified aggregate
interfaces.
reset counters interface
[ {
bridge-aggregation
|
route-aggregation
} [ interface-number ] ]
Ethernet link aggregation configuration examples
Layer 2 static aggregation configuration example
Network requirements
On the network shown in Figure 13, perform the following tasks:
• Configure a Layer 2 static aggregation group on both Device A and Device B.
• Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other
end.
• Enable VLAN 20 at one end of the aggregate link to communicate with VLAN 20 at the other
end.
Figure 13 Network diagram
To Next Page
Loading...
