60
This feature takes effect only when the per-flow load sharing mode is used and the per-flow load
sharing mode does not use the following traffic classification criteria:
• Source IP address.
• Destination IP address.
• Source MAC address.
• Destination MAC address.
• Source and destination IP addresses.
• Source and destination MAC addresses.
To configure a link aggregation load sharing algorithm:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure a link aggregation
load sharing algorithm.
link-aggregation global
load-sharing algorithm
algorithm-number
By default, algorithm 5 is used.
If the device fails to load share
traffic flows across all Selected
ports, you can specify algorithm 1
to 13 in sequence until the
problem is solved.
3. Configure a link aggregation
load sharing algorithm seed.
link-aggregation global
load-sharing seed
seed-number
By default, algorithm seed 0 is
used.
Setting the global load sharing mode for MAC-in-MAC traffic
MAC-in-MAC traffic can be load shared based on any of the following items:
• The outer frame header, and source and destination ports.
• The inner frame header, and source and destination ports.
To set the global load sharing mode for MAC-in-MAC traffic:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the global load sharing
mode for MAC-in-MAC
traffic.
link-aggregation global
load-sharing minm
{
inner
|
outer
}
By default, MAC-in-MAC traffic is
load shared based on the inner
frame header, and source and
destination ports.
Enabling link-aggregation traffic redirection
This feature redirects traffic on a Selected port to the remaining available Selected ports of an
aggregation group if one of the following events occurs:
• The port is shut down by using the shutdown command.
• The slot that hosts the port reboots, and the aggregation group spans multiple slots.
This feature ensures zero packet loss for known unicast traffic, but does not protect unknown unicast
traffic.
You can enable link-aggregation traffic redirection globally or for an aggregation group. Global
link-aggregation traffic redirection settings take effect on all aggregation groups. A link aggregation
group preferentially uses the group-specific link-aggregation traffic redirection settings. If
To Next Page
Loading...
