212
Enabling GVRP compatibility
Enable GVRP compatibility for MVRP when the peer device supports GVRP. Then, the local end can
receive and send both MVRP and GVRP frames.
When you enable GVRP compatibility, follow these restrictions and guidelines:
• GVRP compatibility enables MVRP to work with STP or RSTP, but not MSTP.
• When the system is busy, disable the Period timer to prevent the participant from frequently
registering or deregistering attributes.
For more information about GVRP, see the IEEE 802.1Q standard.
To enable GVRP compatibility:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable GVRP compatibility.
mvrp gvrp-compliance enable
By default, GVRP compatibility is
disabled.
Displaying and maintaining MVRP
Execute display commands in any view and reset commands in user view.
Task Command
Display MVRP running status.
display mvrp running-status
[
interface
interface-list ]
Display the MVRP state of a port in a
VLAN.
display mvrp state interface
interface-type interface-number
vlan
vlan-id
Display MVRP statistics.
display mvrp statistics
[
interface
interface-list ]
Clear MVRP statistics.
reset mvrp statistics
[
interface
interface-list ]
MVRP configuration example
Network requirements
As shown in Figure 69:
• Create VLAN 10 on Device A and VLAN 20 on Device B.
• Configure MSTP, map VLAN 10 to MSTI 1, map VLAN 20 to MSTI 2, and map the other VLANs
to MSTI 0.
Configure MVRP on Device A, Device B, Device C, and Device D to meet the following
requirements:
• The devices can register and deregister dynamic VLANs.
• The devices can keep identical VLAN configurations for each MSTI.
To Next Page
Loading...
Need help?
General