51
Step Command Remarks
9. Set the short LACP timeout
interval (3 seconds) for the
interface.
lacp period short
By default, the long LACP timeout
interval (90 seconds) is used by
the interface.
To avoid traffic interruption during
an ISSU, do not set the short
LACP timeout interval before
performing the ISSU. For more
information about ISSU, see
Fundamentals Configuration
Guide.
Configuring a Layer 3 aggregation group
Configuring a Layer 3 static aggregation group
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
3. Exit to system view.
quit
N/A
4. Assign an interface to the
specified Layer 3
aggregation group.
a Enter Layer 3 Ethernet
interface view:
interface interface-type
interface-number
b Assign the interface to the
specified Layer 3
aggregation group:
port link-aggregation
group group-id
Repeat these two substeps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
5. (Optional.) Set the port
priority for the interface.
link-aggregation port-priority
priority
The default port priority of an
interface is 32768.
Configuring a Layer 3 dynamic aggregation group
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the system LACP priority.
lacp
system-priority
priority
By default, the system LACP
priority is 32768.
Changing the system LACP
priority might affect the
aggregation states of the ports in
the dynamic aggregation group.
3. Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
To Next Page
Loading...
Need help?
General