EasyManuals Logo

HPE FlexFabric 5940 SERIES Configuration Guide

HPE FlexFabric 5940 SERIES
334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
78
Configuring port isolation
The port isolation feature isolates Layer 2 traffic for data privacy and security without using VLANs.
Ports in an isolation group cannot communicate with each other. However, they can communicate
with ports outside the isolation group.
Assigning a port to an isolation group
The device supports multiple isolation groups, which can be configured manually. The number of
ports assigned to an isolation group is not limited.
To assign a port to an isolation group:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an isolation
group.
port-isolate group
group-id
By default, no isolation groups exist.
3. Enter interface view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• The configuration in Layer 2
Ethernet interface view applies only
to the interface.
• The configuration in Layer 2
aggregate interface view applies to
the Layer 2 aggregate interface and
its aggregation member ports. If the
device fails to apply the configuration
to the aggregate interface, it does
not assign any aggregation member
port to the isolation group. If the
failure occurs on an aggregation
member port, the device skips the
port and continues to assign other
aggregation member ports to the
isolation group.
4. Assign the port to the
isolation group.
port-isolate enable group
group-id
By default, the port is not in any isolation
group.
You can assign a port to only one isolation
group. If you execute the
port-isolate
enable group
command multiple times,
the most recent configuration takes effect.
Displaying and maintaining port isolation
Execute display commands in any view.
Task Command
Display isolation group information.
display port-isolate group
[ group-id ]

Table of Contents

Other manuals for HPE FlexFabric 5940 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexFabric 5940 SERIES and is the answer not in the manual?

HPE FlexFabric 5940 SERIES Specifications

General IconGeneral
BrandHPE
ModelFlexFabric 5940 SERIES
CategorySwitch
LanguageEnglish

Related product manuals