55
Step Command Remarks
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
N/A
3. Set the minimum number of
Selected ports for the
aggregation group.
link-aggregation selected-port
minimum
min-number
By default, the minimum number
of Selected ports is not specified
for an aggregation group.
4. Set the maximum number of
Selected ports for the
aggregation group.
link-aggregation selected-port
maximum
max-number
By default, the maximum number
of Selected ports for an
aggregation group is 32.
Setting the expected bandwidth for an aggregate interface
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• Enter Layer 3 aggregate
interface or subinterface
view:
interface
route-aggregation
{ interface-number |
interface-number.subnumbe
r }
N/A
3. Set the expected bandwidth
for the interface.
bandwidth
bandwidth-value
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided by
1000.
Configuring an edge aggregate interface
When you configure an edge aggregate interface, follow these restrictions and guidelines:
• This configuration takes effect only on the aggregate interface corresponding to a dynamic
aggregation group.
• Link-aggregation traffic redirection does not operate correctly on an edge aggregate interface.
For more information about link-aggregation traffic redirection, see "Enabling link-aggregation
traf
fic redirection."
To configure an edge aggregate interface:
Step Command Remarks
1. Enter system view.
system-view
N/A
To Next Page
Loading...
