HPE FlexFabric 5940 SERIES Configuration Guide

263
Step Command Remarks
2. Enter Layer 2/Layer 3
Ethernet interface view,
management Ethernet
interface view, Layer 2/Layer
3 aggregate interface view, or
IRF physical interface view.
interface
interface-type
interface-number
N/A
3. Enable LLDP polling and set
the polling interval.
• In Layer 2/Layer 3 Ethernet
interface view or management
Ethernet interface view:
lldp [ agent { nearest-customer |
nearest-nontpmr } ]
check-change-interval interval
• In Layer 2/Layer 3 aggregate
interface view:
lldp agent { nearest-customer |
nearest-nontpmr }
check-change-interval interval
• In IRF physical interface view:
lldp check-change-interval
interval
By default, LLDP polling is
disabled.
Configuring the advertisable TLVs
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2/Layer 3
Ethernet interface view,
management Ethernet
interface view, Layer
2/Layer 3 aggregate
interface view, or IRF
physical interface view.
interface
interface-type
interface-number
N/A

HPE FlexFabric 5940 SERIES Specifications

General

Brand	HPE
Model	FlexFabric 5940 SERIES
Category	Switch
Language	English