HPE FlexFabric 5940 SERIES - Page 323

313
parameter
spanning tree timeout factor, 111
PE
L2PT
configuration, 278, 280, 282
L2PT
for LACP configuration, 283
L2PT
for STP configuration, 282
per-flow lo
ad sharing, 48
perfo
rming
spanning tree mCheck, 119
spa
nning tree mCheck globally, 119
spa
nning tree mCheck in interface view, 120
per-pa
cket load sharing, 48
Per-VLA
N Spanning Tree Protocol. Use PVST
PFC (Ethernet interfac
e), 7
phy
sical
Ethernet interface physical state change
suppression, 5
polling
Ethernet interface stati
stics polling interval, 9
LLDP
enable, 262
port
aggregate interface (MAC address), 53
Ethernet ag
gregate interface, 52
Ethernet ag
gregate interface (description), 52
Ethernet ag
gregate interface (Layer 3
edge), 76
Ethernet interface fiber p
ort (Layer 2), 12
Ethernet lin
k aggregate group Selected ports
min/max, 54
Ethernet lin
k aggregate interface (expected
bandwidth), 55
Ethernet lin
k aggregate interface (Layer 2
edge), 70
Ethernet lin
k aggregate interface default
settings, 57
Ethernet lin
k aggregate interface
shutdown, 57
Ethernet lin
k aggregation (dynamic mode), 44
Ethernet lin
k aggregation (Layer 2
dynamic), 66
Ethernet lin
k aggregation (Layer 2 static), 64
Ethernet lin
k aggregation (Layer 3
dynamic), 73
Ethernet lin
k aggregation (Layer 3 static), 71
Ethernet lin
k aggregation (static mode), 43
Ethernet lin
k aggregation
configuration, 41, 48, 64
Ethernet lin
k aggregation configuration
types, 42
Ethernet lin
k aggregation edge aggregate
interface, 48, 55
Ethernet lin
k aggregation group, 49
Ethernet lin
k aggregation group (Layer 2
static), 49, 50
Ethernet lin
k aggregation group (Layer 2), 49
Ethernet lin
k aggregation group (Layer 3
dynamic), 51
Ethernet lin
k aggregation group (Layer 3
static), 51
Ethernet lin
k aggregation group (Layer 3), 51
Ethernet lin
k aggregation group load sharing, 58
Ethernet lin
k aggregation LACP, 45
Ethernet lin
k aggregation LACP port priority, 45
Ethernet lin
k aggregation load sharing (Layer
2), 68
Ethernet lin
k aggregation load sharing (Layer
3), 74
Ethernet lin
k aggregation load sharing algorithm
settings, 59
Ethernet lin
k aggregation load sharing mode, 48
Ethernet lin
k aggregation local-first load
sharing, 59
Ethernet lin
k aggregation member port, 41
Ethernet lin
k aggregation member port
state, 41, 43, 46
Ethernet lin
k aggregation modes, 43
Ethernet lin
k aggregation operational key, 42
Ethernet lin
k aggregation reference port, 46
Ethernet lin
k aggregation reference port
choice, 43
Ethernet lin
k aggregation traffic redirection, 60
isolatio
n. See port isolation
Layer 2 ag
gregate interface (ignored VLAN), 53
Layer 3 ag
gregate interface configuration
(MTU), 54
link ag
gregation management subnet, 62
link ag
gregation management
VLAN+management port, 61
LLDP
basic configuration, 261, 272
LLDP
configuration, 254, 260, 272
LLDP
disable operating mode, 259
LLDP
enable, 261
LLDP
frame encapsulation format, 268
LLDP
frame reception, 260
LLDP
frame transmission, 259
LLDP
operating mode, 261
LLDP
polling, 262
LLDP
reinitialization delay, 262
LLDP
Rx operating mode, 259
LLDP
Tx operating mode, 259
LLDP
TxRx operating mode, 259
loop dete
ction configuration, 141, 143, 145
loop dete
ction enable (port-specific), 143
loop dete
ction interval, 142, 144