Installing the Installing the boot deviceboot device
4. If installed, remove the front bezel .
5. Power down the server.
6. If installed, open the cable management arm .
7. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
8. Disconnect all peripheral cables from the server.
9. Remove the server from the rack .
10. Place the server on a flat, level work surface.
11. Remove the access panel .
12. Remove the secondary riser cage.
13. Remove the security cover to allow hot-plug access to the SSDs.
To Next Page
Loading...
