23. Power up the server .
24. If removed, install the front bezel .
ResultsResults
The installation is complete.
M.2 SSD optionsM.2 SSD options
The server supports the installation of M.2 SATA and NVMe SSD options for:
Booting up from flash solution
Data backup/redundancy
In this server, M.2 SSD support is provided through the following options:
Installing the HPE NS204i-u controller option
Installing an M.2 SSD
SubtopicsSubtopics
Installing an M.2 SSDInstalling an M.2 SSD
Installing an M.2 SSDInstalling an M.2 SSD
PrerequisitesPrerequisites
Use Intel VROC to configure M.2 SSDs.
If you are installing M.2 NVMe SSDs, the Intel VROC Standard license is required to support RAID 0/1 configuration. For more
information on Intel VROC licenses, see the product QuickSpecs:
https://buy.hpe.com/us/en/p/1014696061https://buy.hpe.com/us/en/p/1014696061
Before beginning installation, make sure that the server is updated with the latest operating system firmware and drivers.
Before beginning installation, make sure that the server is updated with the latest operating system firmware and drivers.
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
