HPE ProLiant DL320 Gen11 - Results; Installing an AC power supply; Prerequisites; About this task

9. Immediately slide the power supply into the bay until it clicks into place.
10. Make sure the -48 V DC power source is off or the PDU breaker is in the off position, and then connect the power cord to the -48 V DC
power source or PDU.
11. Turn on the -48 V power source or switch the PDU breaker to the on position to supply -48 V to the power supply.
12. Connecting a DC power cable to a DC power source
13. Make sure that the power supply LED is green.
ResultsResults
The installation is complete.
Installing an AC power supplyInstalling an AC power supply
PrerequisitesPrerequisites
Before installing a power supply option, review the Power supply warnings and cautions .
About this taskAbout this task
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply, power supply blank, or dual slot
power supply adapter to cool before touching it.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
HPE ProLiant DL320 Gen11 Server User Guide 118