To install the server into the rack, the inner rails are inserted (stabbed) into the mounting rail.
Friction rack rails are a nontelescoping rail—you must remove the server from the rack to perform internal server procedures.
This server supports the following rack rail options:
Rack rail option #1 for SFF drive configuration
Rack rail option #2 for LFF drive configuration
Rack rail option #5 for GPU dense configuration
Rack rail option #9 for three row LFF drive configuration
ProcedureProcedure
Installing the inner rails on the serverInstalling the inner rails on the server
1. Attach the inner rails to the server:
a. Insert the spools on the sides of the server through the keyed slots on the rails.
b. Slide the rail towards the rear panel to lock it into place.
Installing the mounting rails on the rackInstalling the mounting rails on the rack
2. Locate the orientation markers on the mounting rails.
The front end of the rails is marked as FRONT LEFTFRONT LEFT or FRONT RIGHTFRONT RIGHT.
The other end of the rails is marked as REARREAR.
To Next Page
Loading...
