22. Power up the server .
23. If removed, install the front bezel .
ResultsResults
The installation is complete.
Installing an optical drive in the LFF drive chassisInstalling an optical drive in the LFF drive chassis
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
The components included with the hardware option kit
LFF optical cable option kit
An optical drive
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Remove the middle cover .
10. Remove the optical drive bay blank.
Retain the drive bay blank for future use.
To Next Page
Loading...
