Remove the fan wallRemove the fan wall
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver—This tool is required to remove the fan wall from the 12 LFF or the 4 SFF or 8 E3.S drive configuration.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Remove the access panel .
7. Remove the middle cover .
8. Remove the fans.
9. Remove the fan wall.
Retain the screws and fan wall. These screws will be used to secure the fan wall after replacing or installing the internal component.
SFF or 4 LFF drive configuration:
To Next Page
Loading...
