Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS. If an application stops
responding, you can use this method to force a shutdown.
Use a virtual power button selection through iLO 6.
This method initiates a controlled remote shutdown of applications and the OS before the server enters standby mode.
Before proceeding, verify that the server is in standby mode by observing that the system power LED is amber.
Open the cable management armOpen the cable management arm
ProcedureProcedure
1. Press and hold the blue PUSHPUSH button on the retention bracket.
2. Swing the arm away from the rear panel.
Extend the server out of the rackExtend the server out of the rack
PrerequisitesPrerequisites
Before you perform this procedure, review the Rack warnings and cautions.
T-25 Torx screwdriver—This tool is required if the shipping screws located inside the chassis ears are secured.
About this taskAbout this task
WARNING:WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release latches. The inner rails could pinch
your fingers.
To Next Page
Loading...
