6. Install the server into the rack.
ResultsResults
The installation is complete.
Installing the rack rail hook-and-loop strapInstalling the rack rail hook-and-loop strap
About this taskAbout this task
If you do not require in-rack serviceability for your rack-mounted server, use the rack rail hook-and-loop strap, instead of a CMA, to manage
the rear panel cables. The hook-and-loop strap can be installed on either the left or right rack mounting rail.
ProcedureProcedure
1. Attach the strap carabiner to the rack mounting rail.
2. Bundle the rear panel power cords and peripheral cables, and then wrap the strap around the cables.
Installing the cable management armInstalling the cable management arm
PrerequisitesPrerequisites
Before you perform this procedure, review the Rack warnings and cautions.
T-25 Torx screwdriver—This tool is required if the shipping screws located inside the chassis ears need to be loosened or tightened.
About this taskAbout this task
The cable management arm (CMA) allows the server to be fully extended from the rack without the need to power off the system or
disconnect any rear panel cables. This CMA is designed for ambidextrous implementation.
For the purpose this procedure, left and right terminology is from the perspective of a user facing the front of the rack.
To Next Page
Loading...
