18. If installed, close the cable management arm.
19. Power up the server .
20. If removed, install the front bezel .
ResultsResults
The installation is complete.
PCIe riser optionPCIe riser option
SubtopicsSubtopics
Installing a riser board in the secondary riser cageInstalling a riser board in the secondary riser cage
Installing a riser board in the secondary riser cageInstalling a riser board in the secondary riser cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
To Next Page
Loading...
