SubtopicsSubtopics
Processor cautionsProcessor cautions
Installing a processor heatsink assemblyInstalling a processor heatsink assembly
Processor cautionsProcessor cautions
CAUTION:CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or
install the processor in this server.
CAUTION:CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must
contain processors with the same part number.
CAUTION:CAUTION: The pins on the processor socket and on the processor are very fragile and easily damagedThe pins on the processor socket and on the processor are very fragile and easily damaged . To avoid component
damage, do not touch these pinsdo not touch these pins . Any damage to them might require replacing the system board and/or processor.
IMPORTANT:IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.
IMPORTANT:IMPORTANT: If installing a processor with a faster speed, update the system ROM before installing the processor. To
download firmware, see Updating firmware or system ROM .
Installing a processor heatsink assemblyInstalling a processor heatsink assembly
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-30 Torx screwdriver available.
About this taskAbout this task
This server supports Intel® Xeon® Scalable Processor XCC and Intel® Xeon® Scalable Processor MCC where the keying features are different
between the two processors. The processor carrier clip for an Intel® Xeon® Scalable Processor XCC is E1A. The processor carrier clip for an
Intel® Xeon® Scalable Processor MCC is E1B.
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
To Next Page
Loading...
