18. Power up the server .
ResultsResults
The installation is complete.
Installing a type-o storage controllerInstalling a type-o storage controller
PrerequisitesPrerequisites
The flash-backed write cache (FBWC) feature of some storage controllers requires the installation of an energy pack option. For more
information, see the controller QuickSpecs on the Hewlett Packard Enterprise website (https://www.hpe.com/info/qshttps://www.hpe.com/info/qs).
Before you perform this procedure, make sure that you have the following items available:
Compatible controller cable option
T-10 Torx screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
To Next Page
Loading...
