SubtopicsSubtopics
Power up the serverPower up the server
Power down the serverPower down the server
Open the cable management armOpen the cable management arm
Extend the server out of the rackExtend the server out of the rack
Remove the server from the rackRemove the server from the rack
Remove the front bezelRemove the front bezel
Remove the access panelRemove the access panel
Remove the M.2 air baffleRemove the M.2 air baffle
Remove the middle coverRemove the middle cover
Remove the fanRemove the fan
Remove the fan wallRemove the fan wall
Remove the riser cageRemove the riser cage
Install the access panelInstall the access panel
Install the M.2 air baffleInstall the M.2 air baffle
Install the middle coverInstall the middle cover
Install the fan wallInstall the fan wall
Install the riser cageInstall the riser cage
Install the server into the rackInstall the server into the rack
Power up the serverPower up the server
About this taskAbout this task
To power up the server, use one of the following methods:
Press the Power On/Standby button.
Use the virtual power button through iLO 6.
Power down the serverPower down the server
Before powering down the server for any upgrade or maintenance procedures, perform a backup of critical server data and programs.
IMPORTANT:IMPORTANT:
When the server is in standby mode, auxiliary power is still being provided to the system.
To power down the server, use one of the following methods:
Press and release the Power On/Standby button.
This method activates a controlled shutdown of applications and the OS before the server enters standby mode. It can also activate a
shutdown behavior governed by an OS configuration or policy.
To Next Page
Loading...
