7. Determine the status of the drive from the drive LED definitions .
8. Configure the controller .
ResultsResults
The installation is complete.
Installing an Installing an E3.SE3.S drive drive
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Remove the drive blank.
Retain the blank for future use.
4. Prepare the drive.
5. Install the drive.
To Next Page
Loading...
