HPE ProLiant DL320 Gen11

Installing an accelerator in the rear riser cageInstalling an accelerator in the rear riser cage
Installing an accelerator in the GPU riser cageInstalling an accelerator in the GPU riser cage
PrerequisitesPrerequisites
Before installing this option, do the following:
Be sure that the power supplies support the installation of this option. For more information, see the Hewlett Packard EnterpriseHewlett Packard Enterprise
Configurator websiteConfigurator website.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION:CAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation
procedure. Improper grounding can cause electrostatic discharge.
The accelerators are supported in slot 4 and 5.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Remove the middle cover .
10. Remove the GPU riser cage .
11. Remove the GPU bracket retainer (callouts 1 and 2) and the GPU riser slot blank (callout 3).
HPE ProLiant DL320 Gen11 Server User Guide 129