ResultsResults
The installation is complete.
The System Intrusion Detection setting in the UEFI System Utilities is automatically enabled after installing the chassis intrusion detection
switch. To view a log of intrusion events, use the iLO web interface to access the IML or the iLO event log. For more information, see the iLO
user guide on the Hewlett Packard Enterprise website (https://www.hpe.com/support/ilo-docshttps://www.hpe.com/support/ilo-docs).
Internal USB device optionInternal USB device option
The server has an internal USB 2.0 port to install a USB device that can be used as a flash boot media or for data backup/redundancy.
SubtopicsSubtopics
Installing an internal USB deviceInstalling an internal USB device
Installing an internal USB deviceInstalling an internal USB device
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel .
6. Locate the internal USB port.
7. Remove the primary riser cage.
8. Plug in the USB device into the USB port.
9. Install the primary riser cage .
To Next Page
Loading...
