20. Power up the server .
ResultsResults
The installation is complete.
Installing an accelerator in the rear riser cageInstalling an accelerator in the rear riser cage
PrerequisitesPrerequisites
Before installing this option, do the following:
Be sure that the power supplies support the installation of this option. For more information, see the Hewlett Packard EnterpriseHewlett Packard Enterprise
Configurator websiteConfigurator website.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
The accelerator can be installed in the primary or secondary riser cage.
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION:CAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation
procedure. Improper grounding can cause electrostatic discharge.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
