b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Remove the riser cage.
10. Remove the existing rear guide bracket from the card, if installed.
11. Install the card in the riser cage.
12. Install the riser cage.
13. Install the access panel .
14. Install the server into the rack .
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. If installed, close the cable management arm.
To Next Page
Loading...
