11. To remove the GPU riser cage, do the following:
a. Remove the two screws (callout 1).
b. Push the cage forward and slide it out (callout 2).
Install the access panelInstall the access panel
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. With the access panel latch open, insert the guide pin on the chassis through the hole on the bottom side of the latch.
2. Close the access panel latch.
The access panel slides to the closed position.
3. Lock the access panel latch.
To Next Page
Loading...
