CAUTION:CAUTION:
Support the CMA during the removal and replacement procedures. Do not allow the CMA to hang by its own weight during
the procedure.
ProcedureProcedure
1. Connect and secure all peripheral cables and power cords to the rear panel.
2. (Optional) The CMA retention bracket can be rotated to fit a left- or right-hand CMA operation. Press and hold the rotate mechanism
(callout 1), and then rotate the bracket 180° (callout 2).
There will be an audible click to indicate that the bracket is locked in its adjusted position.
3. Connect the CMA hinged tabs and retention bracket to the rack rails:
a. Insert the inner tab into the slide rail (callout 1).
b. Insert the outer tab into the mounting rail (callout 2).
c. Insert the retention bracket into the opposite mounting rail (callout 3).
There will be an audible click to indicate that the tabs and bracket are locked into place.
To Next Page
Loading...
