Installing the Installing the E3.SE3.S drive cage drive cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
The components included with the hardware option kit
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Remove the middle cover .
10. Install the E3.S drive backplane onto the drive cage.
11. Connect the drive cables to the drive backplanes:
Drive power cable
Storage controller cables
12. Install the E3.S drive cage.
To Next Page
Loading...
