PrerequisitesPrerequisites
Before beginning installation, make sure that the server is updated with the latest operating system firmware and drivers.
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Phillips No. 1 screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
Installing drives onto the Installing drives onto the boot deviceboot device
1. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callouts 2).
c. Slide the carrier out from the boot device cage (callout 3).
2. Install the SSD on the boot device carrier:
a. Remove the SSD mounting screw.
To Next Page
Loading...
