HPE type-p storage controller
Ethernet adapter
HDR InfiniBand adapter
Fibre channel host bus adapter (FC HBA)
Accelerator (workload, computational, or graphics accelerator)
For more information on the expansion options validated for this server, see the server QuickSpecs on the Hewlett Packard Enterprise
website:
https://buy.hpe.com/us/en/p/1014696061https://buy.hpe.com/us/en/p/1014696061
SubtopicsSubtopics
HPE Smart Storage Hybrid CapacitorHPE Smart Storage Hybrid Capacitor
Installing an expansion cardInstalling an expansion card
HPE Smart Storage Hybrid CapacitorHPE Smart Storage Hybrid Capacitor
The HPE Smart Storage Hybrid Capacitor supports the following devices:
HPE SR controllers
The capacitor pack can support up to two devices.
This server supports the HPE Smart Storage Hybrid Capacitor with the 145 mm cable.
Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum firmware requirements to
support the capacitor pack.
IMPORTANT:IMPORTANT:
If the system BIOS or controller firmware is older than the minimum recommended firmware versions, the capacitor pack
will only support one device.
The capacitor pack is fully charged after the system boots.
Installing an expansion cardInstalling an expansion card
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
About this taskAbout this task
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a
riser slot blank or an expansion card installed.
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
To Next Page
Loading...
