b. Connect each power cord to the power source.
20. If installed, close the cable management arm.
21. Power up the server .
22. If removed, install the front bezel .
ResultsResults
The installation is complete.
Optical drive optionOptical drive option
SubtopicsSubtopics
Installing an optical drive in the SFF drive chassisInstalling an optical drive in the SFF drive chassis
Installing an optical drive in the LFF drive chassisInstalling an optical drive in the LFF drive chassis
Installing an optical drive in the SFF drive chassisInstalling an optical drive in the SFF drive chassis
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this taskAbout this task
To Next Page
Loading...
