5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the secondary riser cage.
9. Remove the OCP slot blank:
a. Remove the blank screw (callout 1).
b. Remove the blank (callout 2).
Retain the screw and blank for future use.
10. Install the type-o storage controller:
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Slide the controller into the bay until it clicks into place (callout 2).
Make sure that the controller is seated firmly in the slot.
c. Rotate the locking pin to the close (horizontal) position (callout 3).
To Next Page
Loading...
