Huawei ECC500 - ECC500 Network Fault

ECC500
User Manual
6 Maintenance and Troubleshooting
Issue 05 (2020-03-16)
Copyright © Huawei Technologies Co., Ltd.
101

The networked device is faulty.
Procedure
Step 1 Check whether the communications cable between the ECC500 and the networked device is
disconnected.

If yes, reconnect the communications cable.

If no, go to Step 2.
Step 2 Check whether the parameters are correctly set for the networked device. For details, see
5.2.10 Adding a Networked Device.

If yes, go to Step 3.

If no, reset the communications parameters.
Step 3 Check whether the network is proper.

If yes, go to Step 4.

If no, repair the network.
Step 4 Check whether the networked device is faulty.

If yes, repair the networked device.

If no, contact Huawei technical support.
----End
6.2.6 ECC500 Network Fault
Description
This alarm is generated when the ECC500 is disconnected from the network.
Attribute
Alarm ID
Alarm Severity
Alarm Type
-
Warning
Alarm
Impact on the System
After the alarm is generated, a short message is sent to the mobile phone of maintenance
personnel and prompt maintenance is required.
Possible Causes

The communications cable is disconnected.

The ECC500 is faulty.